CORRECT CRAFT G21 Návod k obsluze

PHOTOVOLTAIC SYSTEM CONTROLLERSOPERATOR’SMANUALPROROSTARTARMODEL RATINGSPROSTAR-12 PROSTAR-20 PROSTAR-30Rated PV current 12A 20A 30A Rated Load curren

105.0 OPERATION5.1 CONTROLLEROPERATIONThe ProStar is a fully automatic PV system controller thatincludes many electronic functions to protect both th

11Automatic Safety • Load Short-Circuit: Instant loadDisconnects disconnect. The LED’s flash in sequence. Battery must be disconnected to clear and re

126. Inspect for dirt, insects, nests, and corrosion.7. Check that the controller functions and LED indicators arecorrect for the system conditions at

13the battery. This will cause undercharging of the battery. See section 4.2-4.g. Check the condition of the battery. Determine if the batteryvoltage

14d. If there is a problem with high voltage, the controller shouldgo into the High Voltage Disconnect mode (see section 5.2). 3. LOADNOTOPERATINGPRO

6.0 TECHNICAL SPECIFICATIONS15MECHANICAL• Dimensions: (inches) ... 6.01 (W) x 4.14 (H) x 2.17 (D)(mm) ... 153 (W) x 105 (H) x 55 (

P.O. BOX958OLNEY, MARYLAND20830 USAR1- APRIL 1996

2CONTENTS1.0 GENERALINFORMATION... 22.0 QUICKSTARTINSTRUCTIONS...

3• Even though the system is only 12 or 24 volts, both the PVarray and battery can contain lethal amounts of electricalpower.• Do not splash water on

43. Connect the BATTERYfirst. Observe that all LED’s flash insequence one time.4. Connect battery SENSEleads (if utilized). This is recom-mended if th

5BATTERY CHARGEGreen ON: Battery near full charge BATTERY CHARGEYellow ON: Battery at middle capacity (about 35% to 80% SOC)NOTE: does not indicate a

64.0 INSTALLATION INSTRUCTIONS4.1 POLARITYPROTECTION(ANDLED INDICATIONS)CAUTION: Although the ProStar is fully protected fromreversed polarity, the s

74.2 INSTALLATIONPROCEDUREGENERAL INSTALLATION NOTES:• The ProStar prevents reverse current leakage at night, so a blocking diode is not required in t

8Multiple ProStar units can be paralleled at the system battery,but be careful that no PV sub-array exceeds a controller’sindividual current rating.3.

9CHARGINGindicator comes on after 2 minutes to confirmthat the PV array has been properly connected.6.LOAD (+ and -)Turn the load off. Connect the loa